ELASTOSIL LR 5040/60 A/B is a paste-like, easily pigmentable two-component liquid silicone rubber with very low volatiles content and excellent mechanical properties with no required post-cure. Articles made from ELASTOSIL LR 5040/60 A/B exhibit high transparency, excellent electrical properties, and mechanical properties engineered for high tear resistance according to DIN ISO 34-1 A (trousers) and ASTM D 624 B (crescent) without post-curing. The ability to meet regulatory requirements for specific food and baby care applications without need for post-curing offers key advantages in cost-savings and productivity. 

Specific features

• Fast curing

• Food-contact 

• High tear-resistant 

• Low volatile

Applications

• Baby Care

• Dairy Applications

• Medical Equipment 

• Molded Parts

• Sanitary

Applications details

ELASTOSIL LR 5040/60 A/B is designed for the automated, high volume production of injection moulded articles. Properly cured vulcanizates of ELASTOSIL LR 5040/60 A/B can be used for food contact applications and are suitable for use under the Recommendation "XV. Silicones" of the BfR and FDA 21 CFR §177.2600 "Rubber Articles Intended for Repeated Use" considering any given limitations on extractable and volatile substances. Properly cured materials meet the limit of 0.5 % for volatile substances in accordance with BfR “XV. Silicones”, DIN EN 1400:2014-07 and DIN EN 14350-2:2004-11, respectively. Consequently, post-curing may not be necessary, however, as the results may vary with the processing conditions and the geometry of the finished article, it is the responsibility of the person placing the article on the market to verify compliance with all relevant requirements and regulations. Since the measured volatile content increases with decreasing thickness of a part, in particular very thin-walled articles have to be carefully checked for compliance with any relevant limitations for volatile matter. 

The following studies were performed on vulcanizates of ELASTOSIL LR 5040/60 A/B according to ISO 10993: 

- Hemocombatibility (Hemolysis and Thrombogenicity) (ISO 10993-4)

- Cytotoxicity (ISO 10993-5)

- Sensitation LLNA (ISO 10993-10)

- Pyrogenicity (ISO 10993-11)

The following studies were performed on vulcanizates ofELASTOSIL LR 5040/60 A/B according to USP class VI: 

- Acute systemic toxicity

- Intracutaneous toxicity

- Implantation test

No adverse effects have been detected at any of the studies performed.